For woodworking, you want wood with few defects and as good a grain pattern as possible. For the most part, you want the top two grades of wood: Firsts and Seconds. These two are often grouped together and referred to as FAS (Firsts and Seconds). Most decent lumberyards are well stocked with FAS boards and some Selects. The common classes aren’t used in furniture-making because they contain far too many defects.
Working on one side at a time, glue and nail the side to the back. Apply glue and drive three 1-5/8-in. nails into each shelf, attach the other side and nail those shelves into place to secure them. Clamps are helpful to hold the unit together while you’re driving nails. Center the top piece, leaving a 2-in. overhang on both sides, and glue and nail it into place. Paint or stain the unit and then drill pilot holes into the top face of each side of the unit and screw in the hooks to hold your ironing board. Mount the shelf on drywall using screw-in wall anchors.
In researching the Sloyd tool cabinet shown at left I found some old tool catalogs from Chandler & Barber of Boston (a primary supplier of Sloyd paraphernalia), including one from 1900 complete with a list of pricing for all the tools in the cabinet. This got me thinking. According to the Federal Reserve’s website, $1 in 1900 should be worth about $27 today. Yet a straight monetary conversion doesn’t paint a complete picture since some tools that were common back then are a specialty today, and vice versa. So I created a spreadsheet that includes columns for the original hand tool prices, those same prices adjusted for inflation and actual prices for similar tools from today’s retailers. Click here to see that spreadsheet.
Block planes have become one of the most oft-used tools in a woodworker’s workshop. Some traditional woodworkers even keep them in their aprons! These little planes can be used to trim your joints, put chamfers on board edges, trim end grain, etc. I would recommend finding a low angle block plane, because the low angle lets you cut difficult grain more easily.
But that’s not all. In this chapter I talk about one of modern times’ greatest gifts to the woodworker: manufactured boards (also called sheet goods) and veneers. Yep, wood technology can help you keep your sanity while also speeding up the process of making furniture. Oh, and it can also save you some bucks in the process. What’s not to like about that?
Woodworking For Dummies shows you how your raw building materials stack up, with everything you wood need to know about hardwood, softwood, plywood, veneer wood, plain-sawn wood, rift-cut wood, quarter-sawn wood, solid wood, man-made wood, and more. This down-to-earth guide gives you the goods on how boards are made from trees and the characteristics of hardwood and softwood species, plus all the buzz on