now I finally know what to recommend my friends when I try to convince them to give handtools a try (I currently am doing an apprenticeship in cabinetmaking (unfortunately mostly particle board) and said friends they do the same and often have no clue what can be achieved with handtools alone) because up until now, I never knew what to recommend for sharpening as my setup is great but very expensive. And I guess if I recommend to get two stones instead of a combination stone, one can keep one side flat for flattening the backs of new chisels, and add a strop with some polishing compound I really can’t think of anything else one would need for a long time!
I have used a Workmate successfully for years and I am in the process of building an upgraded replacement for the work surfaces. My replacement bench top will be a little longer, much thicker and it will have and extended apron between the two halves to greatly improve holding wood vertically for dovetailing. With this simple upgrade it turns the little Workmate into a very capable portable woodworking bench.
The first step in developing woodworking skills is to be able to discern the best glues, joints (ways of connecting two pieces of wood), and fasteners to use. Whether you need a dovetail joint for a drawer front or a mortise-and-tenon joint for a table leg, Chapter 10 introduces you to the wonderful world of wood joints. With an understanding of the joints in Chapter 10, you can build any furniture project and make it strong and durable.
Like you, I too am benchless. I built the “Mozilla” Molson vice variant from last year’s issue (I forget which) and it comes in handy for a lot of operations. I clamp it down to a piece of plywood that I have covered with formica (actually, it’s two pieces that I have piano-hinged together for easier storage) laid across two sawhorses. As long as lateral thrust is not involved, this is a pretty stable way to work. I also have a Zyliss vise for working on smaller pieces. I’ve made do for nearly forty years with a radial arm saw and circular saw. I have only recently acquired a planer and router table (both on wheels) It makes the garage croweded because also sharing the space are two motorcycles and about 400 board feet of rough sawn Camphor. I currently attend classes in woodworking and this coming semester I’ll be enrolled in a class for handtools only (and sharpening).
The key to making furniture is having a plan. (Or is that the key to life? I always forget.) The good news for beginning woodworkers is that you don’t need to develop the plan; you need only to follow it. Project plans are abundant and easily found (check out Chapter 21 for some project-plan resources). After you get familiar with the way plans are written, you can build just about anything (depending on your skills, of course).